01-25-2018 Garage Party Homewood, AL

[Fencejumper09]

Updated to 1-25-18

Plan to hang out and maybe help some people build some skid plates out of plastic!

Bring whatever you need to work on and we will try to figure it out!!

Tire stand and spoons are available as well!

Post up below if you are interested in attending. BYOB if you are too uppity for Coors Light!

Probably mostly some of this going on!


Before 7 or After 7:30pm (Baby goes to sleep at 7 so try to avoid showing up right at 7)
144 Ridgemoor Drive
Homewood, AL 35209

[springer]

Might be able to make this. ;)

[Fencejumper09]

Bueller.........................................Bueller

Any interest? We can postpone if not!

[bblass]

I can't make it tonight unfortunately. Down for next week if you postpone

[springer]

 Tonight or next Thursday night, I can make.  ;)

[Chuck & Susan]

Now next Thursday night I might can make. I'll be leaving Tuscaloosa about lunch time.  8)

Chuck

[Fencejumper09]

I guess I better get to work on the Goldwing!!

[Fencejumper09]

Changed date to 01-25-2018 

[Chuck & Susan]

Not trying to rush ya..... lol

Just thought I'd stop in and supervise all the work that's not getting done.....  :D

[bblass]

How frisky are you feeling for this event? I've got an exhaust that needs aligning/remounting on the 200

[Fencejumper09]

Not sure I have the "right" tools for that job but, we can give it a try!

[Spicciani2]

My zuma125 needs a bash plate....but It doesnt want to drive that far.....

[Mulley]

How frisky are you feeling for this event? I've got an exhaust that needs aligning/remounting on the 200

I need to bend one for my Beta 300 also. Let me know what you end up doing. I was thinking a tree, a pry bar and a torch. Then I'll throw some cuss words at it and hope some stick. Mine is bent so bad that it won't even go back on the bike. It's also an FMF Gnarly so it's a thicker gauge steel than oem.

[bblass]

Mine is an FMF Gnarly as well. It will go on the bike but leaves a nice little gap at the bottom where it mounts to the jug. Thinking prybar & torch as well but I'm not above grinding off a bit of the mounting lip to get it flush

[springer]

I need to bend one for my Beta 300 also. Let me know what you end up doing. I was thinking a tree, a pry bar and a torch. Then I'll throw some cuss words at it and hope some stick. Mine is bent so bad that it won't even go back on the bike. It's also an FMF Gnarly so it's a thicker gauge steel than oem.

Mine is an FMF Gnarly as well. It will go on the bike but leaves a nice little gap at the bottom where it mounts to the jug. Thinking prybar & torch as well but I'm not above grinding off a bit of the mounting lip to get it flush

A local tube bending shop might be able to help with this. Using a mandrel while bending will help to keep the pipe from collapsing on it's self.